sjava wrote:
The S42 engine was a 2.0L touring car engine with a 86.5mm bore and around a 85mm stroke, which shared the same block as the street going M42. Unlike the common M42, the S42 had a more sophisticated engine management system, and had individual throttle bodies. The S42 unfortunately did not share the same valvetrain as the M42, and is a solid lifter valvetrain (possibily from the S50Euro) fully capable of over 9000rpm, but was limited to a 8500rpm redline, as dictated by touring car rules. It was mounted upright in the bay, not slanted, and ran on a full dry sump oiling system. The pistons had a static compression ratio of around 12:1, and running on pump gas, the S42 made around 280hp (and up to around 310hp later in it's life). Good luck finding more information on the internet about the S42, it's next to impossible.
Oh, and no, the S42 cams will not fit
S42B20 (Version: 08/1995):
* Stroke = 85mm
* Bore = 86.5mm
* Compression ratio = 12.4:1
* Total displacement = 1.997ccm
* Rod length = 145mm
* Inlet cam = 312 degrees (spread: 94) (Eö=40, Es=48 (@ 2mm lift) )
* Exhaust cam = 304 degrees (spread: 9 (Aö=45, As=28 (@ 2mm lift) )
* Inlet Valve diameter = 35mm
* Exhaust valve diameter = 32mm
* Inlet port metrics: W=52mm, H=29.7, Radius=14.85mm
* Slide throttle diameter = 46mm
* Header = 4-2
* ECU = ECU4A.1
* Power DIN 70020 = 285PS / 207kw @ 8300rpm
* Torque DIN 70020 = 245Nm @ 7000rpm
* Max rpm = 8500rpm (FIA regulation "SuperTouring"
* Gasoline quality = Super Plus (Oktan min. ROZ 9
a S42
Takk fyrir þetta
Hef oft leitað að svona mótor t.d á ebay.de og bara á spjallborðum en aldrei fundið annað en þessar myndir sem þú póstar. Væri alveg til í svona
_________________
E30 - 325iC - 323iA - 320i - 318iS
E21 - 320
Honda CBR600 F2 Streetfighter
Login
Register
FAQ
Search
Meðlimur
t.d. þök húdd eða slíkt,
