i thought cross posting this in both areas might increase my chances of good advice

if all you are going to do is flame me, just leave the thread and thats that. I ****ed up badly the other night. The oil light came on, i got oil, put it in and accidently dropped the oil cap down below the engine. heres where i ****ed up- i temporarily plugged the uncapped oil hole with a sock and the sock got sucked into it after about 5 mins of driving. its wrapped around the cam shaft-im pretty sure thats what it is... and i need some advice on how to get it out without shelling a shitload of money out to bmw to take it in there. should i unbolt the top piece there and cut it out and then flush the whole thing with some stuff at kragen or just try to cut it out piece by piece through the hole with a sharp razor and take the pieces out with needle nose pliers and then flush it?

please any advice or help on this crap move i made would really really really help me out.

thanks to anyone who replies

Wow you are an idiot.

Sell the car and get a honda with a warranty and never touch it again.

... hey - did you run that in perminant press, or high heat? was the sock a clean sock, or dirty? did it get all the wrinkles out? and most importantly, how many pairs of jeans can you fit into it? my washer only holds 12 pairs. looking to upgrade. let me know.